Publicidad
Idiomas disponibles
Idiomas disponibles
1. Wiring disposition – use a panel removal tool to remove (3) wiring attachments from driver side
frame rail.
3. Hitch installation – feed the carriage bolt ① and spacer ② into frame rails using pull wires ⑤, see Figure 1, 2, 3. Leave pull wires
attached. Raise the hitch into position and slide it over passenger side exhaust first. Feed pull wires previously installed through bracket
holes. Remove pull wires and loosely install conical washer ③ and hex nut ④ to the hitch.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
2. Hole enlargement – use a die grinder to enlarge
the foremost hole on passenger side frame rail to
feed the spacer ②, see Figure 2.
Sheet 4 of 15
24948NP
08-01-16
Rev. A
Publicidad
