Horizon Global 24965 Instrucciones De Instalación página 6

1. Lower mufflers – Lower muffler(s) by removing the rearmost rubber
hanger(s) and the rubber hanger near rear axle. A spray a lubricant on
rubber hangers makes them slide off metal pins more easily. NOTE:
Be careful that exhaust is supported before removing rubber hangers.
3. Remove drivers side plastic appearance panel (if present) – Either return
to vehicle owner or see figure 10 for optional trimming of panel.
©2017 Horizon Global™ Corp - Printed in Mexico
2. Remove factory muffler hanger bracket(s) - Remove (2) hex nuts per
hanger bracket to remove. Return bracket(s) and fasteners to vehicle
owner.
4. Remove plastic appearance panel (if present) covering space between
bumper fascia and trunk pan – Remove and return to vehicle owner.
Sheet 6 of 24 24965NP 8-7-17 Rev. A