Install Washing Machine; Tools Needed - Infiniton WM-K10IN Manual De Usuario

Install Washing Machine

NOTE
We recommend that your new washer should to installed by a qualified
appliance technician.If you feel that you have the skills to install the
washer,please read the installation instructions carefully before
installing.

Tools needed

You may need to have the following tools to help you in the installation
of your washer:
Scissors
Gloves
Standard Screwdriver
Unpacking the washing machine
Unpacking your washing machine and check if is there any damage
during the transportation.Also make sure that all the the items(as
shown below) in the attached bag are received. If there is any damage
to the washing machine during the transportation,or any item is
missing or damaged,please contact the local dealer immediately.
If your washing machine is not double inlet, you do not have the hot inlet hose.
Inlet Hose
Hot Inlet Hose
(Connect to cold
(Connect to Hot
water supply)
water supply)
*If washing machine is not double inlet, the machine does not have the hot inlet hose.
Select the location
Before installing the washer,the location characterized as follows shall
be selected:
-Rigid,dry,and level surface(if not level,please make it level with
reference to the following figure'Adjustable Leg').
-Avoid direct sun light.
-Sufficient ventilation.
-The ambient temperature shall be between 0-40℃.
-The ambient humidity shall be below 95%(When the temperature is
25℃).
-Keep far away from the heat resources such as coal or gas.Make sure
that the washer will not stand on power cord.Do not install the washer
on the carpet floor.
Pliers
Spanner
Hole Cover (4EA)
Support Bracket
(Used to plug transit
(Used to loop the end
bolt holes)
6
Drain Hose
(1.Used to adjust the bottom
of the machine,
2.Remove the transport bolt on
of drain hose)
the back of the machine)
Spanner