Hardware Installation - Nvidia QUADRO GV100 Guia De Inicio Rapido

03

HARDWARE INSTALLATION

1
Remove the current graphics driver installed on the host
system.
•
Go to Start\Control Panel\Programs and Features
•
Remove the current graphics driver.
2
Power down your system.
3
Unplug the power cord from the AC power source.
4
Remove the side panel from your system to gain access to
the motherboard.
5
Remove the existing graphics card if present. If a retention
bar is holding the card in place, remove the screw securing
the card. OR, If there is no existing graphics card, remove the
access covers from the primary x16 PCI slot.
Note: Reference your specific computer documents for
instructions on accessing the motherboard in your computer.
The Quadro GV100 is a dual-slot
GPU and will require removing
two adjacent slot covers.
Quadro GV100 Quick Start Guide | Page 3
EN