Installation - Glacier bay HD67771W-6001 Guía De Uso Y Mantenimiento

Installation

1
Installing the faucet assembly
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Remove the preassembled lock nut (C) and
washer (B) from the new faucet (A).
□
WITH FLANGE: Before installation, ensure that
the ange (P) is placed on the bottom of the
new faucet (A). Place the faucet (A) through the
mounting holes in the sink until the faucet (A)
sets on top of the sink.
□
WITH DECK PLATE: Before installation, remove
the ange (P). Align the hole in the gasket
(E) and deck plate (D) with the mounting hole in
the sink. Place the faucet (A) through the deck
plate (D) and mounting hole in the sink until
the faucet (A) sets on top of deck plate (D).
NOTE: If the sink is uneven, use silicone under the
gasket (E).
2
A
P
A
D
E
4
Securing the faucet
□
Secure the faucet (A) to the sink using the
washer (B) and lock nut (C) provided.
NOTE: When you insert the lift rod (O), the lift rod (O) can
go through the faucet (A) and down into the slot of the
washer (B).
1
C
C
B