Sauder 421191 Manual Del Usuario página 19

Step 14
Position your unit in its fi nal location. We recommend using the SAFETY STRAP for added stability.
å
NOTE: Do not turn the SAFETY DRYWALL ANCHOR into a wall stud. If you prefer to fasten the SAFETY STRAP to a wall
å
stud, go to your local hardware store for proper hardware.
INSTALLATION INSTRUCTIONS:
å
1. Insert the SAFETY DRYWALL ANCHOR through the WASHER and one end of the SAFETY STRAP.
2. Using a Phillips screwdriver or a hand drill, press the screw slightly onto the drywall just below the top surface of your
unit so the SAFETY STRAP will not be visible.
3. Apply pressure; turn the screw until a pilot hole is made and the nylon sheath slips through.
4. Turn the screw until it is fl ush against the wall and you feel a fi rm resistance.
5. Continue to turn until the screw starts spinning freely.
NOTE: Before moving your unit to a diff erent location, unscrew the SAFETY DRYWALL ANCHOR from your wall. The
å
nylon sheath will remain behind your wall.
www.sauder.com/service
Washer
421191
Safety
drywall
anchor
Safety strap
97
Page 19