BEFORE FIRST USE
• Before use, remove all packing materials, including bottom cushions, foam pads
and tapes inside of the freezer; tear off the protective film on the doors and the
freezer body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or
watery places to prevent rust or reduction of insulating effect.
• Do not spray or wash the freezer; do not put the freezer in moist places easy to
be splashed with water so as not to affect the electrical insulation properties of the
freezer.
• The freezer is placed in a well-ventilated indoor place; the ground shall be flat, and
sturdy (rotate left or right to adjust the wheel for levelling if unstable).
• The top space of the freezer shall be greater than 70 cm, and The freezer should
be placed against a wall with a free distance more than 20 cm to facilitate heat
dissipation.
Note: Before using the appliance for the first time, wash the interior and accessories
with lukewarm water and a little detergent to remove the typical smell of the new
product. Dry the interior and all parts carefully afterwards.
You can set the temperature with the control knob on the thermostat. The further you
move the knob towards level "3", the lower the temperature. This setting is usually
sufficient. The temperature is highest at level 1 and lowest at level 4. The actual
temperature depends on the amount of food and how often the door is opened. To save
electricity, we recommend that you do not overfill the appliance and that you open the
door as seldom as possible.
EN
25