Installing The Thermostat - Honeywell TH114-AF-GA Guía Para El Usuario

Owner's Guide

Installing the thermostat

Turn the heating system off at the main electrical panel.
Faceplate
Loosen the bottom screw and remove the thermostat faceplate from
its wallplate. (The screw cannot be completely removed.)
Connect the thermostat to the load and to the power supply (see
page 7).
If the thermostat will be used in F or AF mode (see page 9), connect
the floor sensor (see page 8).
If you wish to connect a remote control device, see page 8.
Install the wallplate to the electrical box using the provided screws.
Set the configuration switches on the back of the faceplate (see page
9).
Wallplate
Install the faceplate back on the wall plate and tighten the screw. If
there is a sticker on the screen, peel it off.
Apply power to the heating system at the main electrical panel.
Test the ground fault protection (see page 12).
6