Removing/Replacing Air Filters - Antec Signature Serie Manual Del Usuario

2.5 Removing / Replacing Air Filters
Figure 11
Central Intake Air Filter
1. The filter is located in the Air Intake on the side of the Motherboard Chamber.
2. While facing the left side of the case, pull the lower tab down by grabbing the top portion of the tab as
shown in figure 11 and figure 12.
3. You will see another tab at the bottom of the filter. Pull this tab and slide the filter out of the Central Air
Intake (figure 13).
4. After cleaning and drying the filter, slide the filter back into place and close the tab.
Power Supply Intake Air Filter
1. The filter is located at the bottom of the power supply.
2. Slide the filter toward the rear of the case to remove (figure 14).
3. Clean and dry the filter, then slide the filter into place.
Hard Disk Drive Intake Air Filter
1. While facing the left side of the case, open the side panel as shown in Section 2.1, Figure 4.
2. The filter is located inside the Hard Disk Drive Chamber just above the top hard drive rails (figure 15).
3. Slide out the filter as shown. Clean and dry the filter, then slide the filter back into place.
12 S10 User Manual
Figure 12
Figure 14
Figure 13
Figure 15
rev 1C