Specifications; Troubleshooting - Sanyo VMC-L2617 Manual De Instrucciones

L8MAP_MAQ_US_XE_JP(GB_FE_ES_DE_CS_JP).book 9 ページ ２００９年７月７日 火曜日 午後４時５７分

Specifications

Model
Display type
Color system
LCD display
Viewable size (H x V)
Pixel pitch (H x V)
Horizontal resolution
Viewing angle degree
Scanning frequency
Contrast ratio
Brightness
Response time Tr/Tf
Display color
Display monitor timing
Display mode
Input connector
Video signal (BNC IN)
S-Video signal (Y/C IN)
Audio signal (AUDIO IN)
VGA signal (VGA IN)
Output connector
Video signal (BNC OUT)
S-Video signal (Y/C OUT)
Menu language
Power input
Operating condition
Storage condition
Power consumption
(Consumption current)
Weight
Features and specifi cations are subject to change without prior notice or obligations.

Troubleshooting

Before requesting service or repair, perform a check as described in the following section. If this does not work,
return the unit to the place of purchase or authorized repair agent to undergo adjustment.
Problem
No image is displayed.
No sound is heard.
The display is dark.
There is a hissing noise.
The remote controller cannot be
operated.
9 English
VMC-L2617/L2617P
NTSC/PAL (Automatic detection)
17" active matrix
TFT LCD panel
338 x 270 mm/13.3 x 10.6 in. (4:3)
0.264 x 0.264 mm/0.01 x 0.01 in.
1280 x 1024, NTSC: 600 PAL: 620 TV lines (Y/C input mode)
Horizontal: 30 kHz – 81 kHz, Vertical: 56 Hz – 75 Hz
VESA compatible (VGA mode)
Video A, Video B, S-Video, VGA
2 x Composite sync signal, 1.0 V(p-p), 75 Ω BNC connector
Separate Y/C signal, mini-DIN connector
Y signal: 1.0 V(p-p), 75 Ω negative sync
C signal: 0.286 V(p-p), 75 Ω negative sync
2 x –6.0 dBs (400 mVrms), 2W (1W+1W) stereo, RCA pin
VGA Monitor Connector (15-pin)
Red signal, Green signal, Blue signal: 0.7 V(p-p), 75 Ω positive sync
2 x Composite sync signal, 1.0 V(p-p), 75 Ω BNC connector
Separate Y/C signal, mini-DIN connector
Y signal: 1.0 V(p-p), 75 Ω negative sync
C signal: 0.286 V(p-p), 75 Ω negative sync
English/Chinese/French/German/Spanish/Italian/Portuguese/Dutch/Swedish/Russian/
Temperature: 0°C – +40°C/32°F – 104°F
Humidity: 10% – 90% (non-condensation)
Temperature: –20°C – +45°C/–4°F – +113°F
Approx. 6.0 kg/13.2 lbs.
• Is the connected device outputting a video signal?
• Is the connection correct? (Page 5)
• Using the Input Menu and SOURCE button, is the correct source selected? (Page 8)
• Is the connected device outputting an audio signal?
• Is the connection correct? (Page 5)
• Check the volume level is not set to 0. (Page 4)
• Are the brightness and contrast set to the correct level? (Page 7)
• Effects of this type may be caused by temperature changes in the room but do not indicate
a fault.
• Turn the remote controller toward the IR sensor of the monitor.
(Within 30° horizontally to the left and right of the IR sensor) (Page 4)
• Operate the remote controller within 7 m of the IR sensor. (Page 4)
• Remove or avoid any obstacles when using the remote controller.
• The battery is spent and should be replaced.
• Install the battery correctly and make sure the polarity (
• Check that the Remote ID matches the System ID. (Page 6)
VMC-L2619/L2619P
SXGA a-Si TFT LCD
19" active matrix
TFT LCD panel
376 x 301 mm/14.8 x 11.9 in. (4:3)
0.294 x 0.294 mm/0.012 x 0.012 in.
Left/Right/Up/Down: 80°
1000:1
2 2
300 cd/m / 359 cd/yd
1.3/3.7 m/sec
16.7 M
Korean/Japanese
AC100 – 240 V
Humidity: 5% – 95%
Approx. 42 W (0.7 A)
Approx. 6.9 kg/15.2 lbs.
Points to check
+ -
, ) is correct.