Publicidad
Idiomas disponibles
Idiomas disponibles
Loosen the screw of the strap spool
cover using a screw driver (see
fig.3). Extract screw so far as to be
able to lift the strap spool cover off
(see fig.4).
Inside the appliance the spool disc
will become visible and the rail for
fastening the shutter strap is located
at its centre.
Now insert the strap into the strap
coiler from the top (see fig.5) and
slide it into the appliance until it
reaches the middle of the strap
spool disc and you can get a hold of
the end of the strap. Make sure that
the shutter strap is not twisted at any
point from exiting the wall until
reaching the shutter strap coiler. In
order to insert the end of the strap
into the rail of the strap spool it is
possible to touch the rail of the spool
and pull it out a little (see fig.6)
Insert strap into the strap spool as
shown in fig.7. The end of the strap
should protrude on the right hand
side approx. 3 cm. Turn strap spool
to the right in clockwise direction
until strap has wrapped itself around
the rail twice (see fig.8) and push the
extracted strap spool back into the
coiler.
Now close the shutter strap coiler
back up with the strap spool cover
and refasten the screw as shown in
fig.3 using a screw driver.
3
5
7
4
6
8
709156-2GB
Publicidad
