Giatsu ROUND R32 GIA-C9I-18ROUR32 Manual De Usuario E Instalacion página 58

Installation of the Unit
● Installing the Panel
1. Remove the cover board on the corners of the
panel. (Pull up the motor cover, then pull out
other three as the picture shows.)
2. Keep the panel's swing motor and the pipes
connected to the machine on the same side by
adjusting the direction of the panel.
3. Fit 4 hooks to the panel of the machine.
4. Fit the panel to the machine with screws.
5. Adjust the outlet location.
6. Tighten the bolts until the panel and the thickness of the sealing material between indoor
machine reduces to 5-8 mm, and put back the cover plate.
the ceiling
Fig.35
24
Hooks
Indoor unit
sealing material
The outlet
Decorative panel
Fig.34
5-8mm