Cequent Towing Products 28501 Instrucciones De Instalación

Frame Rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 28501F
Wrenches: 10mm, 14mm, 17mm
Drill Bits: None
Tie-down
Brackets
Fasteners
1
Qty. (4) Hex Bolt, M10 x 1.25 x 40mm
2
Qty. (4) Conical Washer, 3/8"
1. Lower the exhaust by loosening rear two exhaust hangers.
2. Remove tie-down brackets as shown in FIGURE 1. Return brackets and bolts to vehicle owner.
3. Remove and retain bolts from fascia tabs. See FIGURE 1.
4. Raise hitch in place above the fascia tabs (not shown) and install fasteners into existing weld nuts in frame as shown in
FIGURE 2.
5. Install the fascia tabs back onto the vehicle using the bolts that were retained from Step 3.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2005 Cequent Towing Products
Installation Instructions
Fascia
Drawbar must be used in the
RISE position only.
Retain
Fascia Tabs
FIGURE 1
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft (57 N-m).
Scion xB
Drawbar Kit:
28451
Adapter Kit:
28351
Fascia
Existing
Weld Nuts
3
Qty. (4)
4
Qty. (2)
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
2000 LB Max Gross Trailer Weight
200 LB Max Tongue Weight
Wiring Access Location: SUV3, SUV4
ALL FASTENERS TYPICAL BOTH SIDES
Frame Rail
FIGURE 2
Bevel Washer
Spacer, 3/8" x 1-1/2" x 2"
28501N 05-08-06
Part Numbers:
28501
Rev. A