Cequent Performance Products 36320 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: F36320
Wrenches: 15mm, 18mm
Drill Bits: None
Passenger's side
Frame rail
M12 fastener removed in
Step 2-retain for re-use
Spring shackle bolts
Removed in step 1
Do not remove
Center bolt
1. Remove (2) rearmost spring shackle mounting bolts, each side, as shown in Figure 2. Retain bolts for hitch installation.
Note: remove only the two outer bolts on each frame rail as shown. It is not necessary to remove center bolts.
2. Remove M12 bolt, just forward of spring shackle, each side, and retain for hitch installation.
3. To raise hitch into position, it will be necessary to pivot one side of hitch as far forward toward axle as possible to manipulate forward mounting
tab over leaf spring, then pivot that side into position. Repeat on other side.
Note: If spring shackle interferes with installation, use screwdriver to gently pry shackle clear of hitch side bracket. After installation, proper
clearance will exist.
4. Install fasteners as shown, re-using existing M10 & M12 fasteners at all attachments.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z 2004, 2005, 2009, 2011, 2015 Cequent Performance Products - Printed in Mexico
Installation Instructions
Chrysler Town & Country* Dodge Grand Caravan*
Only fits vehicles with Stow 'n Go Seating
*
(Sold separately)
Drawbar Kit:
36071
Drawbar must be used in the
RISE position only.
Tubing
Vehicle
Center line
Rear of vehicle
Figure 2
Viewed from under vehicle
Note: Hitch uses all existing
fasteners for installation.
Tighten all M10 CL10.9 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M)
Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
Do Not Exceed Lower of Towing Vehicle
3500 LB (1589 Kg.) Max Gross Trailer Weight
300 LB (136 Kg.) Max Tongue Weight
Wiring Access Location: SUV1, SUV2
Driver's side
Frame rail
M12 fastener removed in
Step 2-retain for re-use
Spring shackle bolts
Removed in step 1
Do not remove
Center bolt
Driver's side
ExistingM10 hex
bolt assemblies
Sheet 1 of 3
Part Numbers:
36910
Manufacturer's Rating or
Existing weldnuts
in vehicle frame
Existing M12 hex bolt
assembly
Figure 1
Passenger's side
N36320 10-19-15
Form: F205 Rev A 5-6-05
36320
90718
06992
U-HAUL
Rev. F