Cequent Performance Products 36363 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 36363F
Wrenches: 13mm, 14mm, 17mm
Drill Bits: None
Hitch Requires ½" Pin and Clip
j
Qty. (4) M10 X 1.25 X 40mm CL 8.8
Lower exhaust by removing two (2) rubber exhaust hangers on the driver's side of the vehicle and one (1) on the passenger's
1.
side of the vehicle.
2. Remove tow hook bracket (see figure 2) by removing five (5) M10 bolts and return to vehicle owner.
3. Raise hitch into position and install four (4) M10 X 1.25 X 40mm bolts and conical toothed washers, two (2) per side.
4. Reattach rubber muffler hangers.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2006, 2015 Cequent Performance Products – Printed in México
Installation Instructions
Hyundai Tucson
Kia Sportage
Fascia
(Sold separately)
Drawbar Kit:
36051
Drawbar must be used in the
Rise position only.
Existing Weldnuts
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
3500 LB Max Gross Trailer Weight
300 LB Max Tongue Weight
Wiring Access Location: SUV1, SUV2
Frame Rail
Fasteners Typical Both Sides
k
Qty. (4) 3/8 Conical Toothed Washer
Sheet 1 of 3 36363N
Part Numbers:
36363
06339
90621
Bumper
Structure
Figure 2
10-19-15 Rev. D