Before First Use - Vollrath JW30PA Manual De Operador

SET UP
Install the legs
NOTICE: Legs must be installed. Failure to install the legs will
restrict airflow and cause the oven to overheat.
Screw the legs onto the threaded nuts below the cheese melter.
Install the Shelf
Insert the pins on the shelf into the slots on the brackets on the sides of
the oven.
FEATURES
A
B
C
Back View
A Fan
B Adjustable Shelf
C On/Off Switch
D Reset Button
2
Front View
35 Inch Plate Activated Cheese Melters Operator's Manual – Model JW30PA

BEFORE FIRST USE

Clean the oven. See "Cleaning" on page 3.
OPERATION
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
Preheat
1. Plug the oven into a grounded electrical outlet that matches the
rating on the name plate found on the oven.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Adjust the shelf to the desired position.
3. Press the On/Off switch to the ON position. The front and rear heater
elements will turn on and the oven will be in standby mode.
4. The center elements will turn on when a plate is placed on the shelf.
Melt Cheese, Finish Cooked Food
1. Place the food on an oven-proof plate and place the plate on the
shelf.
2. The weight of the plate will active the center heating elements to
bring the oven to full power mode.
3. Remove the plate. The oven returns to standby mode.
4. When finished using the oven, press the On/Off switch to the OFF
position.
D