Cequent Performance Products 75214 Instrucciones De Instalación página 4

1. Remove appearance panels on both side near the wheel well and covering the
frame rails, remove (2) hex nuts (M10 socket) on bottom of the frame rail and (2)
hex nuts with a (M5.5 socket) at the bottom of the frame rail. Both sides. Will
need to trim or remove once hitch is in place.
3. Feed the coiled end of the pull wire through rearward hole and out the access hole.
Attach spacer and carriage bolt onto pull wire and feed the fasteners into location
through the hole. Leave pull wires attached. Repeat the same process on the both
frame rails. Note: it may be easier to install the carriage bolt head first. Repeat with
the forward holes. Both frame rails. Note: carriage bolt tight fit into access hole may
be necessary to use a file or wrench to open access hole . See figure 3.
©2015 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Lower the exhaust at the rubber isolators on both sides of the exhaust. Support the
exhaust to prevent damage to the vehicle. Note: Spraying a lubricant or soapy water on
the metal hanger rod and the rubber isolator helps removal.
4. Pull the pull wire with fasteners into location through the hole. Leave pull wires
attached. Repeat the same process on both frame rails. Push the fasteners back
into the frame rails with the pull wire attached, to allow the hitch to go into
position. See figure 2
Access
Hole
Sheet 4 of 18 75214NP 6-11-15 Rev. B