Cequent Performance Products 75214 Instrucciones De Instalación página 6

9. Raise exhaust back into position, spraying a lubricant or soapy water on the metal hanger rod.
Working on one side at a time. Note: the entire rubber isolator can move on the metal rod to re-install
the exhaust it will be necessary to push the rubber isolator toward the outside, while attaching the
remaining metal rod back into position.
With the marker mark out the area to be trimmed, then using the
Utility Knife trim the area.
2" [50.8]
6" [152.4]
Panel trim
©2015 Cequent™ Performance Products, Inc. -
Flat
Head Screw
Driver
Printed in Mexico
10. Trim appearance panel removed in step 1 or return to owner.
Obtain owner permission before trimming.
Re-install appearance panel
Sheet 6 of 18 75214NP 6-11-15 Rev. B