Cequent Performance Products 75647 Instrucciones De Instalación

Plastic Fascia
Hitch Shown In Proper Position
Equipment Required: Small Screwdriver
Fastener Kit: 75647F
Wrenches: 10mm, 16mm, 17mm, 19mm
Drill Bits: None
Existing M12
Weldnuts In
Vehicle Frame Vehicle Frame
1
Qty. (4) Hex Bolt M12 x 1.25 x 30mm CL8.8
2
Qty. (4) Conical Washer – ½"
3
Qty. (1) Hex Bolt M10 x 1.25 x 30mm CL8.8
1. Lower exhaust by removing (3) rubber exhaust hangers from hanger mounting brackets, (2) on driver's side, (1) on passenger's side.
2. Remove tie-down bracket from driver's side frame rail. Return tie-down bracket and fasteners to vehicle owner.
3. Disconnect fascia from valence panel by removing (2) plastic fascia push pins. Return push pins to vehicle owner.
4. Remove valence panel from vehicle bulkhead by removing (4) hex nuts. Return valence panel and nuts to vehicle owner.
5. Raise hitch into position by carefully pulling fascia down to allow clearance for hitch side brackets. Secure with conical washers and M12 hex
bolts into existing weldnuts as shown above.
6. Raise exhaust back into position and re-attach exhaust hangers.
7. Use cable ties to secure plastic fascia to hitch crosstube.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2008, 2010 Cequent Performance Products
Installation Instructions
Nissan Murano
Will not fit with optional Aero kit
12
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3, SUV4
Existing M10 Weldnut
(Tie-Down Bracket
Attachment)
Valence Panel
To Be Removed
Vehicle
Bulkhead
34
4
Qty. (1) Conical Washer – 3/8"
5
Qty. (2) Cable Tie
Sheet 1 of 3 75647N
Part Numbers:
75647
44600
87486
78282 UHAUL 78282 UHAUL
Max Gross Max Tongue
Trailer WT (LB) WT (LB)
Warning: Do NOT use with Spring
Bars
4000 (1816 Kg.) 400 (182 Kg.)
Existing M12 Existing M12
Weldnuts In
Vehicle Frame
12
7-14-10
Form: F205 Rev A 5-6-05
Rev. C