Rear Panel Features; Top Panel Features - Numark M1A Manual De Inicio Rápido

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

REAR PANEL FEATURES

1.
POWER CABLE – Use the attached power
cable to connect the mixer to a power outlet.
While the power is switched off, plug the power
supply into the mixer first, then plug the power
supply into a power outlet.
2.
POWER SWITCH – Turn the mixer on and off
with this button.
3.
MASTER OUTPUT (RCA) – Use standard
RCA cables to connect this output to a speaker
or amplifier system. The level of this output is
controlled by the MASTER knob on the top panel.
4.
LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces,
to these inputs.

TOP PANEL FEATURES

1.
POWER LED – Illuminates when the mixer is
on.
2.
MASTER – This control adjusts the output
volume of the Program mix.
3.
MIC GAIN – Adjusts the audio level of the
microphone signal.
4.
CUE GAIN – Adjusts the level of the
headphone audio.
5.
CUE SLIDER – Slide this to mix between
Channels 1 and 2 in the headphones. When all
the way to the left, only Channel 1 will be heard.
When all the way right, only Channel 2 will be
heard.
6.
CHANNEL GAIN – Adjusts the corresponding
channel's pre-fader and pre-EQ gain level.
7.
CHANNEL TREBLE – Adjusts the high (treble)
frequencies of the audio on the corresponding
channel.
8.
CHANNEL BASS – Adjusts the low (bass)
frequencies of the audio on the corresponding
channel.
9.
CHANNEL FADER – Adjusts the audio level on
the corresponding channel.
10.
CROSSFADER
between Channels 1 and 2. Sliding this to the
left plays channel 1 and sliding to the right plays
Channel 2.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then
remove the screws holding it in position. Replace the fader with a quality authorized replacement from
your local Numark retailer only.
11.
MIC INPUT – Connect ¼" microphones to this input. The microphone controls are located on the top
panel.
12.
HEADPHONES – Connect your ¼" headphones to this output for cueing and mix monitoring.
Blends
audio
playing
2
1
3
6
7
8
9
11
5
4
4
2
6
1
7
3
8
4
5
9
10
12

Publicidad

Tabla de contenido
loading

Tabla de contenido