Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: F75079
Wrenches: 7/8", 18mm
Drill Bits: None
Vehicle frame
j
Carriage Bolt – ½-13 x 1-3/4" GR5
Qty. (6)
k
Qty. (6)
Block ¼ x 1-1/2 x 2
Note: For 1998 and newer models:
With original equipment trailer hitch:
1. Purchase left and right bumper brackets from General Motors dealer (part numbers 15719945 and 15719946)
2. Remove trailer hitch.
3. Install bumper brackets.
Without original equipment trailer hitch:
1. Remove forward bumper bolts (4) and return to vehicle owner.
Hitch Installation:
Raise hitch into position and install (3) ½ x 1-3/4" carriage bolts, blocks, lock washers and nuts as shown, each side. Position
1.
blocks as shown above.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
©1997, 1998,1999, 2000, 2001,2002,2006, 2007, 2008 2014 Cequent Towing Products – Printed in Mexico
Installation Instructions
Chevrolet Blazer
Bumper
Mounting
Bracket
Oldsmobile Bravada
Bumper
Tighten all ½ GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
GMC Jimmy
GMC Envoy
Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV5
l
Lock Washer ½"
Qty. (6)
m
Qty. (6)
Hex Nut ½-13
Sheet 1 of 3
Part Numbers:
78167 UHAUL
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
6,000 (2 724 Kg)
4,000 (1 816 Kg)
Accessory Rating
Fasteners typical
both sides.
N75079
5-13-14
Form: F205 Rev A 5-6-05
75079
44715
87478
Max Tongue
WT (LB)
600 (272 Kg)
400 (182 Kg)
C
Rev. F