Whirlpool Flange
Ledger Strip
16-1/2"
(41.9 cm)
13/16"
(2.1 cm)
Subfloor
7. Secure the Whirlpool to the Stud Framing
This whirlpool is designed for installation into regularly spaced framing. If there is a gap between the edge
of the whirlpool and the stud, then shim the stud in order to bring the stud to within 1/8" (3 mm) of the
whirlpool.
The whirlpool can be attached to the framing using the attachment clips (provided), large-head roofing nails,
or non-tapered flathead screws.
For alcove installations, position the bottom lip of the adjustment clip at the side of the stud and
under the edge of the whirlpool. Slide the adjustment clip into place between the center of the stud
and the whirlpool.
Bend the tab of the clip over the whirlpool flange with a pair of pliers.
Secure the attachment clip to the center of the stud using either large-head roofing nails or
non-tapered flathead screws.
1016904-2-C
Stud Wall
Attachment Clip
2-1/2" D. Overflow
2" D. Drain
13"
(33 cm)
5-1/2" (14 cm)
10" (25.4 cm)
Attachment Clip
13-7/8"
(35.2 cm)
14
For Stud
Pocket
Installation
Sterling