Operating Instructions; Filling The System - EAS ELECTRIC EASCOMPACT Instrucción De Montaje

Operating instructions

Istruzioni per l'uso
Mode d'emploi
Instrucciones de uso
Instruções de operação
Instructions for Commissioning and Filling the System
immediately after assembly; apart from that, the system must be protected against direct sunlight.
The system Protection Fluid is an environmentally friendly corrosion protection concentrate for solar systems. The system
Protection Fluid offers excellent corrosion protection and a stable pH value. The Protection Fluid is necessary for protecting the
system from corrosion. The Protection Fluid can be mixed with water with a maximum hardness of 15°dH.
However, this condensation disappears after a few hours of sunlight.
Make sure that the maximum operating pressure stated on the type plate or in the installation instructions is not exceeded.
Check to make sure that all safety components have been installed in accordance with the hydraulic diagram before you open

Filling the System

CAUTION:
If you do not follow these instructions, the solar storage tank will be irreparably damaged!
CHECK
corrosion.
diagram.
Open the cold water shut-off valve.
Now connect the cold/hot water pipe to the system according to the hydraulic diagram.
allow the remaining air to escape from the system.
Carefully inspect the system for leaks.
System in Unused Condition/Periods Without Hot Water Consumption
8
30°
EN
20°
5-45°
V.1