Installation; Power Cable Connection - Leviton LWCYC-00B Guia Del Usuario

INSTALLATION

LWCYC-00B cyclorama light is equipped with a yoke for suspension mounting. The yoke has a 12mm hole to facilitate the
mounting of a lamp hook. Before hanging the cyclorama light on a lighting bar, the lamp hook should first be mounted and
fixed on the yoke of LWCYC-00B. In order to ensure the safety, LWCYC-00B is also equipped with a safety cable. Ensure the
safety cable is looped through the yoke and connected to a suitable anchor at the other end.
NOTE: Always mount this product in a safe position with adequate ventilation and away from a heat source. Keep flammable
materials away from this product while it is operating. When LWCYC-00B cyclorama lights are used in a parallel manner,
ensure spacing between air outlets of two adjacent cyclorama lights is not be less than 16" (0.4m).

POWER CABLE CONNECTION

The LWCYC-00B utilizes powerCON connectors for power input (blue connector) and power output (white connector). To
avoid overloading, the maximum looping for LWCYC-00B is five units at 220V or three units at 110V. LWCYC-00B comes with
a power cable terminated with a powerCON A connector on one side and a free end on the other side.
The power output allows power to be supplied to subsequent LWCYC-00B cyclorama lights.
NOTE: At 110V, the maximum number of LWCYC-00B cyclorama lights used in relay is three units.
NOTE: At 220V, the maximum number of LWCYC-00B cyclorama lights used in relay is five units.
Leviton provides a complete set of power input cables for LWCYC-00B. Users need to prepare the connecting cables for
input and output. Refer to the following diagram for reference:
Jacket Plug Core
*Attention:
Do not connect or disconnect the powerCON connector under load or live status!
Only authorized and licensed technicians should make power connections!
Chuck
E .79" (20 mm)
.32" (8 mm)
N
PE .9" (23 mm)
L
3
Locking Rear Cap