EAS ELECTRIC E-Advanced 2 Serie Manual De Instrucciones página 85

CONTENTS
Remote controller Specifications...................................................
Function buttons .................. .........................................................
Handling the remote controller ......................................................
Remote LCD screen indicators .....................................................
How to use the basic functions........................................................
How to use the advanced functions ...............................................
Remote Controller Specifications
ECRL66A/ECRL66B
Model
3.0V(Dry batteries R03/LR03×2)
Rated Voltage
Signal Receiving Range 8m
Environment -5 C~60 C O O
NOTE:
Buttons design is based on typical model and might be slightly different from the
actual one you purchased, the actual shape shall prevail.
All the functions described are accomplished by the unit. If the unit has no this
feature, there is no corresponding operation happened when press the relative
button on the remote controller.
When there are wide differences between
, , ,,
USER'S MANUAL on function description, the description of
shall prevail.
V.2
1
2
4
5
6
13
, ,
,,
Remote controller Illustration and
, ,
USER'S MANUAL
1
Function Buttons
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use The Basic/Advance Functions section of
this manual.
NOTE：Please do not select HEAT mode if the machine you purchased is cooling only
type. Heat mode is not supported by the cooling only appliance.
ON/OFF
Turns the unit on or off
MODE
Scrolls through operation
modes as follows:
AUTO  COOL  DRY 
HEAT  FAN
Sleep
Saves energy during
sleeping hours.
TIMER
Sets timer to turn unit on
and off(see How to Use
Basic Functions for
instructions)
LED
,
Turns indoor unit s LED
display on and off.
FOLLOW ME
Temperature sensing and
room temperature display
button.
TURBO
Enables unit to reach
preset temperature in
shortest possible time
,,
FAN
Selects fan speeds in
the following order:
AUTO  LOW 
MED  HIGH
NOTE: Holding this button
down for 2 seconds will
activate Silence feature.
TEMP
Increases temperate in
1 C increments. O
Max. temperature is
Mode ON/OFF Fan
30 C . O
TEMP
Decreases temperate in
1 C increments. O
Swing
Timer Sleep
Min. temperature is
17 C . O
Follow
LED Direct
me
SWING
Starts and stops horizontal
Self
Short
Turbo
clean
cut louver auto swing feature.
DIRECT
Used to set the desired
up/down air flow direction.
The louver changes 6
degree in angle for each
press.
SELF CLEAN
Starts and stops the unit
self clean feature.
SHOUT CUT
Sets and activates your
favourite pre-settings.
Model: ECRL66A
2
V.2