ITM Italia SUNBEAM 20 Manual De Istrucciones página 8

3.
USE
3.1 USE
This is a movable appliance and has been designed for heating closed environments as
well as humid, wet environments such as work sites, warehouses, shops and houses.
3.2 INSTALLATION
Ensure that the electrical characteristics of the power outlet correspond to the values quoted
on page 2.
To ensure correct installation, check the technical specification plate. Installation may only
be carried by suitably skilled personnel in accordance with current legislation.
3.3.1 UTILIZE (STANDARD)
Turning the knob on the selector 8 (Fig.1 - 3) the following occurs:
0 OFF
1 Fan
2 Fan + ½ Output
3 Fan + Max output
Ventilation operation and ventilation/heating operation are controlled by the thermostat 10
(Fig.1). The fan continues to operate when the adjustment thermostat is activated.
3.3.2 UTILIZE (FAN)
When the switch 11 (fig.2) is in "0" position and turning the knob on the selector
8 (Fig.2) the following occurs:
0 OFF
1 Fan
2 Fan + ½ Output
3 Fan + Max output
Ventilation operation and ventilation/heating operation are controlled by the thermostat
10 (Fig.2). The fan continues to operate when the adjustment thermostat is activated.
When the switch 11 (fig.2) is in "0" position the fan is controlled by the cooling thermostat
ST3. The fan starts when the resistance is hot and stops when it's cold.
3.4 SWITCHING OFF AND STOTAGE
1 Set the termostat to position "0".
2 Turn the selector to OFF.
3 Disconnect electrical power.
4 Wind the cable.
GB
2