Clearing The Master Power Macro; Re-Assigning Device Keys; Using Channel Scan - One for All URC-4220 Manual Del Usuario

PROGRAMMING A MASTER POWER MACRO (continued)

Clearing The Master Power Macro

1.
2.
3.

RE-ASSIGNING DEVICE KEYS

The One For All 4 Device Universal Remote Control can be set to control a
second PVR,VCR, or DVD player. For example, to control a TV, a cable box,
and
two DVD players
DVD player as follows:
1.
2.
3.
4.
To re-assign a second VCR or PVR (or DVR) to the unused
steps 1 through 4 . However, in step 3 substitute
4 substitute
DVD
your second VCR or PVR (or DVR). See
8.
NOTE: Only one device can be assigned to an unused device key at a time.

USING CHANNEL SCAN

In the or
CBL/SAT
channels. Or, if programmed, use the
channels to view a desired channel (see
on next page. )
1.
Press and hold
then release
SET
Enter - - . The
9 9 5
once.
Press and hold
. The
Master Power Macro
SET
, re-assign the unused
On the remote control, press and hold
(red light) blinks twice, then release
Enter - -
9 9 2
Press once.
DVD
Press
VCR/PVR
key is now ready to be set up to control your second DVD
player. See
Programming Device Control
for . Now the
VCR/PVR
mode, use the
TV
Press
CBL/SAT
until the
SET LED
.
will blink twice. Then press
LED
until the
SET LED
is now cleared.
VCR/PVR
. The will blink twice.
LED
once. The will blink twice. The
LED
key will be ready to be set up as
DVD
Programming Device Control
key to start a 3-second scan of all
FAV
key to scan only your favorite
FAV
Programming Favorite Channel Scan
or once.
TV
11
(red light) blinks twice,
blinks twice, then release
key to operate the second
until the
SET
.
SET
on page 8.
DVD
for
VCR/PVR DVD
POWER
LED
VCR/PVR
key, repeat
, and in step
on page