Clearing Master Power; Using Keymover; Programming Keymover; Restoring Keymoved Keys To Default Settings - One for All URC-6131nw Guia Del Usuario

All manuals and user guides at all-guides.com
PVR 6 Owners Manual.fm Page 10 Monday, December 20, 2004 11:17 AM
O F A 6-D
NE OR LL EVICE
2. You will see the devices turn on or off
according to your programmed
sequence.
NOTE: The currently-selected device will
always turn on first, followed by the
remaining programmed sequence. After the
master power sequence is complete, the
remote will control the first powered-on
device.
NOTE: If one or more devices does not have a
POWER key, the power off/on sequence may
be slightly delayed when the remote control
signals the device(s). This action is normal.
C M P
LEARING ASTER OWER
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
Enter 9 9 5. The LED will blink twice.
2.
Then press POWER once.
3. Press and hold SET until the LED blinks
twice, then release SET. Master Power is
now cleared.

USING KEYMOVER

The One For All 6-Device PVR Universal
Remote Control (URC-6131nw) includes a
Keymover feature that allows you to map (or
copy) keys from one mode (i.e., source
mode) to another mode (i.e., destination
mode).
NOTE: The following keys cannot be used as a
source or destination: TV, PVR, DVD, CBL/SAT,
AUD, VCR, and SET.
P K
ROGRAMMING EYMOVER
For example, if your VCR does not have
volume control, you can map those keys
(i.e., VOL +, VOL -, and MUTE) from the TV
mode to the VCR mode as follows:
10 Using Keymover
PVR U R
NIVERSAL EMOTE
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 4. The LED will blink twice.
3. For the source mode, press TV once.
4. For the source key, press VOL + once.
5. For the destination mode, press VCR
once.
6. For the destination key, press VOL +
once.
7. The LED will blink twice, indicating
the keymoved sequence is correct.
8. Repeat steps 1 through 7 twice more to
map remaining volume control keys,
substituting VOL - and MUTE as source
and destination keys in steps 4 and 6.
Upon completion of the above procedure,
you can now use your One For All 6-Device
PVR Universal Remote Control (URC-
6131nw) to control the TV's volume and
MUTE in the VCR mode, as well as in the TV
mode.
R
ESTORING
S
ETTINGS

Restoring a Single Keymoved Key

1. Press a device key that has a keymoved
key.
2. Press and hold SET until the LED (red
light) blinks twice, then release SET.
3. Enter 9 9 4. The LED will blink twice.
4. Press the destination key twice (where
the keymoved key is stored). The LED
will blink twice.
Restoring All Keymoved Keys in a Single
Mode
1. Press and hold SET until the LED (red
light) blinks twice, then release SET.
2. Enter 9 9 4. The LED will blink twice.
C
ONTROL
K K D
EYMOVED EYS TO EFAULT