Final Notes - Motorline 60 Manual Del Usuario

Garage Door Opener 60 / 100 / 120
English
Operation Temperature: >-20ºC, <+70ºC
Relative Humidity: <90%
Open and close force: 600N in the 60 version, 1000N in the 100 , 1200N in the 120
Reception frequency: 433.92Mhz
Sensitivity: greater than 1V for correctly received signal (average range 30Mts)
Decoding: Rolling Code
Max. door area to be automatized: 60 (600N): 10m2; 100 (1000N): 15m2;120 (1200N): 18m2

FINAL NOTES

This manual is intended to be used only by technical personnel, with qualification to carry out the installation. No
information given in this manual can be considered of any interest to the end user. No settings or adjustments
contained in this manual can be carried out by the end user. It is important for the installer to show their clients the
correct operational use of the device, including the manual emergency disengagement cord.
Inform the owner about the need for a regular and accurate maintenance, especially regarding a regular check of
the safety devices.
TIPICAL APPLICATIONS
The device (with standard rail) can automatize sectional overhead doors up to 2300mm. In case of a higher door, it
is sold rail extensions, increasing until the desired height.
USER INFORMATIONS
Once the opener has been installed, the user must be informed about how it works and all the risks that can come
from an improper use. The user must avoid placing himself in dangerous situations, such as standing within the
door's operating range when moving. Do not let children play near the door and keep the remote controls out of
their reach.
All servicing, repairs or checks must be carried out by professionally qualified personnel and noted on a
maintenance register kept by the user.
In case of malfunction, the user must call the installer and not attempt to repair it.
MANUAL EMERGENCY DISENGAGEMENT
The opener is equipped with a manual release cord for disengaging the motor from the door (Fig. 09), This
operation must be carried out only in case of emergency , power failure or device malfunction.
Pág. 22