Honeywell HFD-110 Manual De Instrucciones página 4

Ocultar thumbs Ver también para HFD-110:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HFD-110_OM.qxd
5/29/08
REMOVING / CLEANING THE IFD
This IFD
air purifier is equipped with an electronic filter indicator to serve as a
convenient guideline for cleaning the IFD
hours of use and operating power level. This is beneficial because a filter's life
depends on the amount of air and contaminants drawn through it. As you operate
your IFD
Air Purifier, the filter bar indicator will fill-up from left to right. The bar will
continue to fill as you use the unit. Once the bar is completely full, the Filter Reset
button will illuminate – it is time to clean the filters and reset the filter indicator.
To reset the filter clean indicator:
• With the power on, press and hold the Filter Reset button
for 10 seconds, or until the filter bar clears itself (Fig. 5).
NOTE: Depending upon your individual usage (environment,
hours and power level of operation), you may need to check
and clean the filters more or less frequently.
To remove the IFD
• Make certain that the air purifier is OFF and the unit is
unplugged.
• Push the Filter Release button and then gently lift the filter
assembly (Fig. 6a & 6b). The filter assembly will only
release if the button is pushed.
• Remove the pre-filter (see "Cleaning the Pre-filter"), and
set aside.
To clean the IFD
filter:
• After removing the IFD
with a nozzle or brush attachment along the filter to pick-up tiny particles (Fig. 7).
Repeat on both sides.
If your IFD
filter appears to have dirt that has not been removed by vacuuming,
please follow the steps below to wash the IFD
• Turn the power off and unplug the air purifier.
• Remove the IFD
filter from the unit.
• Fill the sink with lukewarm water and add a few drops of mild dish soap (Fig. 8).
• Gently swish the filter in the soap solution to clean.
• Soak the filter for 2-3 minutes. Do not leave for an extended period of time.
• Rinse the filter with clean tap water.
• Shake the filter to remove any excess water.
• Place the filter with the honeycomb side down on a plush towel (Fig. 9).
• Note that the filter may still be discolored even after washing.
This is acceptable and will not affect performance.
• Allow the IFD
filter to dry for a few hours or overnight.
• When the IFD
filter is completely dry, place back into the air purifier.
CAUTION:
• Never place a wet IFD
• The IFD
Filter is NOT dishwasher safe. Do not place the IFD
other extreme hot water conditions.
• Do not use any solvents, strong cleaning agents or flammable liquids to clean the IFD
4
9:42 AM
Page 4
FILTER
and pre-filter based on the air purifier's
filter:
Filter from the air purifier, gently run a vacuum cleaner
filter in your air purifier.
Fig. 6a
Fig. 7
filter.
filter in a dishwasher or subject it to
Fig. 5
Fig. 6b
Fig. 8
Fig. 9
filter.

Publicidad

Tabla de contenido
loading

Tabla de contenido