[English]
This document provides information for customers who purchased the NP64G, NP63G,
NP54G, or NP43G projector. Read this document as well as the Important Information, the
Quick Setup Guide, and the User's Manual (CD-ROM) packaged with your projector.
Main Power Switch
The NP64G, NP63G, NP54G, and NP43G have the Main Power Switch on their rear panel.
To turn on the NP64/NP63G/NP54G/NP43G, follow the steps below.
1. Connect the power cable to the projector' AC IN and the active wall outlet. ( → page 15
of User's Manual)
2. Slide the lens cover to the right to uncover the lens. ( → page 5 of the User's Manual)
3. Press the Main Power Switch to the on position ( I ). The projector will go into standby
mode. When in standby mode, the POWER indicator will light orange and the STATUS
indicator will light green.
4. Press the POWER (ON/STAND BY) button on the projector cabinet or the POWER ON
button on the remote control for 1 second.
The POWER indicator will turn to green and the projector will become ready to use. ( →
page 16 of User's Manual)
To turn off the projector, press the POWER (ON/STAND BY) button on the projector
cabinet or the POWER ON button on the remote control, press the Main Power Switch to
the off position ( ), and disconnect the power cable.
NEC NP64G/NP63G/NP54G/NP43G
User's Manual Supplement