mspa MONO C-MO049 Manual Del Propietário página 14

ALL-IN-ONE CONTROL PANEL
Heater Button
Bubble Button
- Adjust the bubble level by
pressing the button
(L1:300W, L2: 500W, L3:720W)
Ozonator Button
Temperature display: press RESET on PRCD, read the current temperature on the screen.
Heater Button:
The filter will automatically be running for 15 seconds to test the working condition once the HEATER
HEATER
function is started. If there is no abnormality, the heater will keep working until water temperature
reaches the set value. When water temp goes below the set temp, the heater will restart to heat the
water automatically. The constant lighting HEATER icon means the heating system is on working
status. The flash lighting HEATER icon means the heating system is initiating or on insulation mode.
Filter Button:
constantly lighting when the function is activated.
FILTER
NOTE: Filtration cannot be turned off when heating function is on (Whether the heater is running or at
rest). When Heating function is turned off, filtration will be stopped after 30 seconds. Filtration
function can then be activated separately.
NOTE: The auto-filtration system is automatically activated every 4 hours.
Bubble Button:
power is at level 2 (500W). Press the BUBBLE button again, switching to level 3 (720W). Press again
BUBBLE
to enable level 1 (300W). To shut down the function, press the BUBBLE button for 3 seconds.
NOTE:
The bubbling massage function will be shut down automatically after every 20 minutes
operation for safety concern. It cannot be operated within 10 minutes after shutting down.
Down Button
Press HEATER button to start or stop heating.
Press FILTER button to turn the function on/off. The FILTER icon should be
Can adjust among 3 levels of bubbling power. The default bubbling massage
Up Button
14
Filter Button
Timer Button
Celsius/Fahrenheit
Toggle Button