hawa Concepta 40 Instrucciones De Montaje página 31

HAWA Concepta 40/50
7.3
EN FAQs: HAWA Concepta 40/50
Situation
Door does not move
independently into
pocket.
Door does not inde-
pendently move into
the pocket and does
not close completely.
Or
Door does not close
completely.
Extended door is im-
mediately pulled into
the pocket again.
Defective door closing
system due to un-
winding and snapping
of the rope.
Hard, loud slamming
of the door onto the
cabinet.
Cause Solution
Move the upright to the top by means of
Upright guide touches the
lower guide track. the height adjustment.
If necessary, move the hinges on the
upright to the bottom.
The pivot points of the When adjusting the door clearance at
hinges are not on one axis. the top (2*) or bottom (2*) hinge, also
loosen the center hinges (1*) and
tighten them after adjustment.
The retention spring on the Adjust the retention spring more
stop cover cap is set too strongly. (+)
weakly.
The top and bottom of the By adjusting the front scissor
upright are not parallel to bearing, set the upright parallel.
the stop cover caps.
The safety pin was re- Order new door closing system. In-
moved before the rope was stall in the specified order in accor-
attached to the rope sup- dance with enclosed instruction
port. leaflet
1. Hook in the rope
2. Remove the safety pin and
Missing drill-in dampers. Install 3 drill-in dampers, Blum 970A
1002, at front edge, each at hinge
height on the fitting side.
insert it in the bottom of the
holder
31/40