Safety Warnings - Marmitek PROGUARD800 Serie Modo De Empleo

SAFETY WARNINGS

• Do not expose the components of your systems to extremely high temperatures
or bright light sources.
• In case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case
of improper usage of the product or when the product is used for purposes other
than specified. Marmitek does not accept responsibility for additional damage other
than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• The product should only be repaired or serviced by a qualified repairman.
• Keep batteries out of the reach of children. Dispose of batteries as chemical
waste. Never use old and new batteries or different types of batteries together.
Remove the batteries when you are not using the system for a longer period of
time. Check the polarity (+/-) of the batteries when inserting them in the product.
Wrong positioning can cause an explosion.
• Only connect the adapter to the mains after checking whether the mains voltage
is the same as the values on the identification tags. Never connect an adapter
when it is damaged. In that case, contact your supplier.
INTRODUCTION
The OS826 is a wireless siren is a part of the Marmitek ProGuard800 series, and
operates together with the ProGuard800 alarm system. When you wish to know
more about the complete system, its possibilities and its settings, then you can
check out the installation manual or visit www.marmitek.com.
In the event of an alarm the control panel activates the siren and strobe. The siren
is sounded until the end of the siren cutoff programmed at the control panel. After
the siren cutoff has expired, the strobe continues to flash until the system is
disarmed.
INSTALLATION
WARNING: Wear hearing protection when installing the siren.
1. Open the housing. To do so, remove the cover screw located at the bottom of
the housing and lift the front cover away from the rear housing.
2. Remove the strobe cover. To do so, carefully lift the bottom of the strobe
cover away from the rear housing and remove it from the strobe cover holding
hooks.
3. Using a Phillips screwdriver, remove the two screws that secure the metal
anti-vandal casing and lift the casing from the back cover of the siren.
4. Connect a 12VDC or 9VAC, 500mA transformer to terminals 3 and 4 on the
siren's terminal block (polarity is not important) – see Figure 2.
3 © MARMITEK