Assemble Fixture For Ground-Level Installation - Broan-NuTone haven HVRFABL Instrucciones Para El Montaje Y Cableado

Purchase power supply and low voltage cable
Add up the wattage from each NuTone Haven fixture you plan to install in order to determine the
1 ]
minimum wattage of the transformer you need . Each repellent fixture has a load of 9 watts .
Select a properly sized, UL Listed or CSA Certified landscape lighting power supply with secondary
2 ]
output rating of 12 VAC or 15 VAC . The power supply wattage rating should be greater than the
combined wattage of all NuTone Haven fixtures but must not exceed 300 watts .
Follow installation instructions included with your power supply for proper installation location and
3 ]
safety precautions .
Use only UL or CSA approved low voltage landscape lighting cable, suitable for direct burial and is
4 ]
sunlight resistant .
Use the distance from the furthest fixture to the power supply to determine length of cable needed .
5 ]
6 ] Use 16, 14 or 12 gauge cable to ensure proper repellent operation .

Assemble fixture for ground-level installation

Note: Optional mounting flanges are available for deck post or rail installations . Purchase model
HVPFBL (black finish) or HVPFBR (bronze finish) separately and follow instruction included .
1 ] Install ground stakes first to ease installation and prevent fixture damage . Loosen hard soil and
remove stones and rocks before attempting to install ground stakes . Use enclosed striker plate to
protect stakes when hammering . After installation, top of ground stake is flush with grade level .
2 ] Remove wire tie from fixture cable and straighten wire .
3 ] Guide fixture wire through the metal stem . Insert the stem into the fixture head and tighten set
screw .
4 ] Pull fixture wiring completely through opening in the ground stake . Push metal fixture stem into
the ground stake and tighten the set screw .
5 ] Make sure final position provides easy visibility to repellent refill indicator .
5