Test Repellent Circuit Prior To Cable Burial; Bury Cable And Connectors - Broan-NuTone haven HVRFABL Instrucciones Para El Montaje Y Cableado

Test the repellent circuit prior to cable burial
Before landscape cables are buried, temporarily connect each circuit to the power supply and
1 ]
check for proper operation of each fixture .
RTPTLLTNT CIRCUIT - Check operation of the "Repellent" circuit . The green LED will light
2 ]
when repellent is operational .

Bury cable and connectors

1 ] Backfill around the ground stakes and tamp soil firmly after cables are buried
National Electrical Code states burial depth of the wiring should not be more than 6" below grade
2 ]
surface . Check local codes to ensure compliance with regulations
Monitor Usage and Replacement
1 ] Illuminated green LED indicator light on fixture indicates that repellent is operating .
2 ] Green LED indicator light on fixture will flash to indicate that there is approximately 20 hours of
repellent remaining and that it is time to replace the cartridge .
3 ] The NuTone Haven Repellent Cartridge for each fixture will be empty after approximately 216
hours of use .
4 ] Before replacement: Disconnect power to the system . If vaporizer has been operating, allow at
least 1 hour to cool down before handling .
5 ] Once the cartridge has been replaced, reset the timer .
To reset the timer: Reconnect power to the system (LED will flash green on fixture) and press the
6 ]
small round button on the top of the fixture until you hear a click . The timer has been reset, and the
LED will illuminate solid green .
7