Haier QWR04D R Serie Instrucciones De Instalación Y Manual Del Usuario página 11

INSTALLATION INSTRUCTIONS
INSTALLATION SPACE
This is a freestanding wine chiller. The following air
clearances are required around the product.
Top - 2" (50.8mm)
Back - 2" (50.8mm)
Sides - 1" (25.4mm)
Product Dimensions
Height: 32.3in (82.0cm)
Width: 19.6in (49.7cm)
Depth: 23.0in (58.5cm)
Additional Specifications
• A 120 volt 60Hz., 15 or
20 amp power supply is
required. An individual
properly grounded branch
circuit or circuit breaker is
recommended. Install a properly grounded 3-prong
electrical receptacle recessed into the back wall as
shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
REMOVE PACKAGING
• Remove all packing material, tape and protective
plastic coverings.
WARNING
Small objects are a choke hazard for
children. Remove and discard any parts not used.
49-1000564 Rev. 0
INSTALL GASKET
• Push gasket into center rail. The gasket helps with
temperature performance.
DOOR REVERSAL INSTRUCTIONS
• Open the door and unsnap the front trim on the
cabinet. Find the insert on the left side of the trim and
move it to the gap on the right side of the trim.
UNPLUG WIRE CONNECTION
• Unplug the wire connection cable at the top of the
cabinet.
Screws
11