GE RAKUVC1 Instrucciones De Instalación página 5

STEP 6:
the right fan blade support and the left end can be guided into the left fan blade support.
fan blade.
freely without any objectionable noises.
STEP 7:
Installation of the Vent Trim
Use existing thermistor wire
path for UVC wiring harness
2. Route the UVC wiring through the notch in the vent trim for the thermistor wires. On 265V models the UVC wiring
will share this opening with the thermistor wires. Make sure wires are not pinched.
3. Reinstall the seven 5/16" screws removed previously.
Installation Instructions
5