GE RAKUVC1 Instrucciones De Instalación página 9

STEP 10:
Install the Control Panel and Vent Grille
1. Reinstall the black wire mesh to the vent trim by pressing it into place.
2. Reconnect the Control Panel wiring harness and reinstall Control Panel to the chassis.
3. Install the three 5/16" screws removed earlier to secure Control Panel.
4. Reinstall the Vent grille and secure it using the four 5/16" screws removed earlier.
STEP 11:
Enabling UVC Mode
1. Reconnect power and heater wire personality jumper.
4. Press the MODE button until a "
5. Press the +/- keys to change the display to either "
6. Press the Aux set button again to save and exit.
Installation Instructions
" appears on the display.
" for enable or "
9
" for disable.
Printed in the United States
Red
Aux Set
Button