Safety Warning - BLACK&DECKER CD600 Manual De Instrucciones

FEATURES
1. Sawdust outlet
2. Window lever
3. Depth of cut adjustment
4. Guard retracting lever
5. Saw blade locking screw
6. Riving knife
7. Blade guard
8. Parallel fence
9. Window
10. Front handle
11. Carbon brush cover
12. Mitring angle scale
13. Locking screw for mitring adjustment
14. Saw shoe
15. Locking screw for parallel fence
16. Sight guide
17. Mark for straight cut
18. Mark for mitring cut
19. Electronic switch
20. On/off switch
21. Depth of cut scale
22. Secondary locking lever for mitring adjustment
23. Inner washer
24. Outer washer
25. Lock-off button
26. Blade
KS846N, KS850N, KS855N, KS865E/N/KN, 374456N
•
1
•
2
3
•
•
4
5
•
•
6
7
•
8
•
CD600, KS227,
KS840
1
•
3
•
4
•
5
•
•
6
•
7
•
8
CD600 Circ saw ML p01-41
9
•
10
•
•
11
• 12
13
•
14
•
•
15
•
16 (17+18)
19
•
• 25
•
20
• 10
12
•
13
•
14
•
•
15
•
17+18
27
Your product includes some or all of these features.

SAFETY WARNING

Your saw is designed for use with wood cutting blades
only. Do not use stone cutting or metal cutting discs.
PREPARING YOUR CIRCULAR SAW
SETTING THE DEPTH OF CUT ADJUSTMENT
Proceed as follows:
Disconnect the plug from the electricity supply.
3
•
21
•
•
22
than the thickness of the workpiece.
SETTING THE SIGHT GUIDANCE SYSTEM
(NOT CD600/KS227/KS840)
The window and 'sight guide' are designed to enable
accurate cutting everytime the saw is used.
To prepare the guide system for first time use,
proceed as follows:
•
16
and secure in place with the screw provided.
• At the start of every cut align the blade as described
and whilst cutting keep the 'sight guide' in line with
the intended line of cut drawn on the workpiece.
07/01/2000, 3:43 pm
ENGLISH
Loosen the depth of cut
adjustment (3) at the
bottom of the scale.
Move your circular saw
up the scale until the
desired depth of cut is
indicated on the scale
(21). Tighten the screw
(3). The depth of cut
should be 3mm greater
Mark a straight line on
your workpiece to
represent the desired
path of the saw blade.
Whilst viewing through
the saw guard window
align the saw blade teeth
with the intended line of
cut drawn on the
workpiece.
Whilst keeping the saw
in this position, place the
orange 'sight guide' (16)
onto the shoe of your
circular saw. Align the
'sight guide' with the line
drawn on the workpiece
27