Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
JS650L Manual - LAG.qxd
GENERAL SAFETY RULES
WARNING!
Read and understand all instructions. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury. The term "power tool"
in all of the warnings listed below refers to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
WARNING: To reduce the risk of injury, user must read instruction manual.
1) WORK AREA SAFETY
a ) Keep work area clean and well lit. Cluttered or dark areas invite accidents.
b ) Do not operate power tools in explosive atmospheres, such as in the pre s e n c e
of flammable liquids, gases or dust. Power tools create sparks which may ignite
the dust or fumes.
c ) Keep children and bystanders away while operating a power tool. D i s t r a c t i o n s
can cause you to lose control.
2) ELECTRICAL SAFETY
a ) Power tool plugs must match the outlet. Never modify the plug in any way. Do
not use any adapter plugs with earthed (grounded) power tools. U n m o d i f i e d
plugs and matching outlets will reduce risk of electric shock
b ) Avoid body contact with earthed or grounded surfaces such as pipes,
radiators, ranges and refrigerators. There is an increased risk of electric shock if
your body is earthed or grounded.
c ) Do not expose power tools to rain or wet conditions. Water entering a power
tool will increase the risk of electric shock
d ) Do not abuse the cord. Never use the cord for carrying, pulling or unplugging
the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk of electric shock. Replace or repair
damaged cords. Make sure your extension cord is in good condition. Use only 3-wire
extension cords that have 3-prong grounding-type plugs and 3-pole receptacles that
accept the tool's plug.
e ) When operating a power tool outdoors, use an extension cord suitable for
outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric
shock. When using an extension cord, be sure to use one heavy enough to carry the
current your product will draw. An undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. The following table shows the correct
size to use depending on cord length and nameplate ampere rating. If in doubt, use
the next heavier gage. The smaller the gage number, the heavier the cord.
3) PERSONAL SAFETY
a ) Stay alert, watch what you are doing and use common sense when operating
a power tool. Do not use a power tool while you are tired or under the
influence of drugs, alcohol or medication. A moment of inattention while
operating power tool may result in serious personal injury.
b ) Use safety equipment. Always wear eye pro t e c t i o n . Safety equipment such as
dust mask, non-skid safety shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal injuries.
2006.7.26
5:03 PM
SAVE THESE INSTRUCTIONS
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
220V
0-50
51-100 101-200
Ampere Rating
More
Not more
American Wire Gage
Than
Than
0
-
6
18
6
-
10
18
10 -
12
16
12 -
16
14
2
Page 2
51-100
101-150
201-300
16
16
14
16
14
12
16
14
12
12
Not Recommended
Publicidad
Tabla de contenido
