Mounting Of Protector - Makita RBC2100 Manual De Instrucciones

MOUNTING OF PROTECTOR

To meet the applicable safety provisions, only the tool/protector combinations
as indicated in the table must be used.
Be sure to use genuine MAKITA cutter blades or nylon cutting head.
– The cutter blade must be well polished, free of cracks or breakage. If the cutter blade hits against a stone during operation, stop the engine
and check the blade immediately.
– Polish or replace the cutter blade every three hours of operation.
– The outside diameter of the cutter blade must be 230mm (9-1/16"). Never use any blades surpassing 230mm (9-1/16") in outside diameter.
Star Blade
CAUTION: The appropriate protector must always be installed, for your own safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard being in place is not permitted.
– Fix the protector (1) to the clamp (3) with two bolts M6 x 30 (2).
– When using the string head, fit the protector (6) into the protector (1), and
tighten them with two nuts (5) and two screws (4).
Eddy Blade Protector for metal blades Nylon cutting head
(6)
10
Protector for cord cutter
(4)
(5)
(1)