Cleaning And Maintenance - makro GDF3004 Manual De Instrucciones

Installation and operation
Reheating solidified fat in the oil reservoir
• Stir the fat carefully with a wooden spatula several times to prevent splattering. Do not damage the heating element (12)!
• Turn the temperature control knob (15) to the low temperature and let the fat melt slowly.
• Attention! The fat can splatter through the upper solid layer when reheated too fast from a low temperature and partly still too cold!
• Store the deep fryer with solidified fat only at room temperature (
• If the safety thermal cut-out switches off, let the appliance cool completely.
Storing the oil or fat
• You can store frying oil for 3 to 6 months after opening a new bottle. Please observe the oil manufacturer's storage directions on the label.
• When using the appliance often, you can store the oil or fat in the deep fryer under covering. Otherwise store the filtered oil in a properly
closed container in a dark place at room temperature.
Storing the oil in an external container
• Disconnect the power plug from the electrical outlet.
• Let the oil cool completely (approx. 2 hours) before pouring into another container.
• Remove the lid (1), the frying basket (2) and control units (4).
• Pour the oil from oil reservoir (11) into a suitable container and seal it properly.

Cleaning and maintenance

CLEANING
• Rotate the temperature control knob (15) to
• Disconnect the power plug (6) from the electrical outlet. Allow all parts of the appliance and the oil or fat to cool completely.
• Remove the lid (1), frying basket (2) and the heating element cover (10).
• Lift the control unit (4) to remove it from the oil reservoir (11) and housing (7).
For model GDF3004/GDF3024
• Take the oil reservoir (11) out of the housing (7).
• Pour the oil or fat out from the oil reservoir (11) (
the oil in an external container, Disposal of used oil and
fat).
• Wash the lid (1), frying basket (2), oil reservoir (11) and housing (7) with hot soapy water.
• Rinse these parts with clean water and dry thoroughly.
• Clean the control unit (4) with a damp cloth and mild soap solution.
NOTES:
- Remove the frying basket (2), heating element cover (10) and control unit (4) before oil solidifies completely.
- For easier cleaning, you can disassemble frying basket (2) and frying basket handle (13) in the reverse order of the assembly
( Installation).
WARNINGS!
- Do not immerse the control units or power cable with plug in water or other liquids. Never hold these parts under running
water!
- Never use corrosive detergents, wire brushes, or abrasive scourers, metal or sharp implements to clean your appliance.
• Dry all parts thoroughly after cleaning and before use.
• Reassemble the appliance (
STORAGE
• Roll up the power cable (6).
• You can fold the basket handle (13) into the basket (2) for storage.
• Store the appliance with the lid (1) closed.
(IM)601-000170_MAKRO_Deep fryers_booklet_V2_210217.indb 70
(off) position.
For model GDF3008/GDF3028/GDF5008/GDF5028
•
Storing •
•
•
Installation).
Storing the oil or fat)!
Lift up the small handle of the oil outlet tap (9) (fig. d).
Turn the tap to release the oil (fig. e).
Drain the oil completely.
Restore the small handle back to turn off the oil outlet tap (9).
Small handle
70
GB
21/2/17 4:02 pm