Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cool & Warm Mist Oscillating Ultrasonic Humidifier
Control Panel
How To Use
CAUTION: This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of shock, this plug is intended to fit only one
way in a polarized outlet. If the plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature. To do so could result in an
electric shock hazard.
Oscillating Head &
Nozzle
Fig.1
6
Oscillating
ON/OFF Button
Mist Decrease
Button
Mist Indicator
Light Ring
Power Button
Plug unit in to a 120 volt AC electrical outlet. Push the POWER ON/OFF ( )
button to turn unit on.
ATTENTION: When the water in the tank is almost empty, the power will shut off to
indicate to the user to refill water.
Mist Increase and Decrease
There are 5 different levels of mist output from Lowest to Highest. To increase the
mist output, press the MIST INCREASE (
reached. The selected mist level will correspond to the number of sections lit along
the mist indicator light ring. When the maximum mist output has been reached, the
indicator ring light will blink once. To decrease mist, press the MIST DECREASE ( )
button until the mist has decreased to the output level desired. When the minimum
mist output level has been reached, the indicator ring light will blink once. (Fig.2)
Warm and Cool Mist Control
The humidifier is equipped with the option to select warm or cool mist. Each time the
unit is turned on it will start producing cool mist. The mist indicator light ring will glow
with a blue light. To select Warm Mist, press the WARM/COOL MIST button. When
warm mist is selected, the mist indicator light ring will change from blue to red and
warm mist will start being produced. To return to cool mist, press the WARM/COOL
MIST button again. The mist indicator ring will change from red to blue. (Fig.2)
Note: Once warm mist is selected, it will take 15 minutes to heat up before the mist
becomes warm.
Warm/Cool Mist Button
Mist Increase
Button
Power ON/OFF Button
Fig.2
) button until the desired mist output is
7
Publicidad
Tabla de contenido
