Removing The Batteries; Ec Declaration Of Conformity - BLACK&DECKER KC9045 Manual De Instrucciones

ENGLISH
• When using your drill as a screwdriver, always use
the correct size and type of screwdriver bit.
• When using your drill as a screwdriver, lubricating
the screws can assist in fitting the screw. The usual
lubricants are either soap or washing liquid. Apply a
little to the screw.
• When drilling wood, use twist drill bits.
• When drilling metal, use high speed twist drill bits.
• When drilling ferrous metals, use a lubricant. Iron
and brass are drilled without a lubricant.
• Make an indentation with a centre punch at the
centre of the required hole. This will improve the
accuracy.
• Always apply pressure in a straight line with the
drill bit.
TOOL CARE
Do not put excessive pressure on your drill. Use
sufficient pressure to keep your drill/driver biting, but
do not push hard enough to stall the motor.
RECHARGEABLE BATTERIES AND THE ENVIRONMENT
Black & Decker cordless tools use nickel
cadmium (NiCad) batteries or battery packs
which can be charged many times to give long
life and repeatedly full power.
This symbol indicates the NiCad batteries
contained within this unit must be disposed of
properly and not discarded in everyday
Cd
household waste which may be disposed of in
an incinerator or landfill site.
NiCad batteries can be harmful to the
environment and can explode when exposed to
fire. Do not incinerate. Therefore, when your tool
or battery pack needs replacing, think of the
protection of our environment.
Black & Decker recommends the following:
Discharge batteries completely by running the
unit until the energy is completely discharged
and then remove from the tool.
26
After use, remove the
drill bit, open the chuck
jaws fully and tap the
side of the chuck to
remove any sawdust.

REMOVING THE BATTERIES

EC DECLARATION OF CONFORMITY

We declare that units: KC9045, KC9049
conform to 89/392/EEC, 89/336/EEC, EN55014,
EN60335, EN55104, EN50144, EN61000
A weighted sound pressure 70dB (A)
A weighted sound power 83dB (A)
Hand/arm weighted vibration <2.5m/s
Colin Wills - Director of Engineering
BDCI, 4/F, 2 Dai Wang Street, Tai Po Industrial Estate,
Tai Po NT, Hong Kong
The Black & Decker policy is one of continuous
improvement to our product and as such we reserve
the right to change the product specification without
prior notice.
This should only be done
when you want to
discard the tool, in order
to recycle the batteries.
Remove the four screws
securing the two halves
of the clamshell. Open
the clamshell and
remove the batteries.
Dispose of the batteries
in an environmentally
safe manner.
2