Technical Data; Safety Precautions - Metal Works HAE 31508 Manual

Warning!
Read carefully and understand all instructions before operating. Failure to follow the safety
rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required.

Technical data

Sectional
area
HAE31508
1.5 mm
HAE31515 1.5 mm
HAE31520 1.5 mm
HAE32520 2.5 mm
Dimensions : see on pages 10 - 11
Spare parts : see on pages 12 - 14

Safety precautions

Warning: Read and understand all instructions. The warnings, cautions, and instructions
discussed in this instruction manual cannot cover all possible conditions or situations that
could occur. It must be understood by the operator that common sense and caution are
factors which cannot be built into this product, but must be supplied by the operator.
1. Ensure that only the qualified electrician can installs/services this cable reel. And it must not be used by children or
unskilled persons.
2. Ensure that power supply voltage does not exceed maximum voltage rating of reel.
3. Ensure that reel is properly be installed before connecting to power supply.
4. Ensure that all electrical power is removed from reel before servicing.
5. Check for frayed and broken wires before each use.
6. When pull electrical cable from the reel always grasp the electrical cable itself, not the work device.
7. Remove power from the reel immediately when any malfunction occurs.
8. Never remove, tamper with or cut out the safety devices fitted by the manufacture.
9. Do not use the reel in damp or wet conditions. Keep the work area is clean. Avoid put in sundries in cable reel.
10. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles.
Installation
1. The cable reel must be installed in premises conforming to current regulation and standards covering electrical
systems and work environments.
2. Unpack and inspect reel for damage. Turn by hand to check for smooth operation. Check for completeness
3. For overhead ceiling mounting: Install reel at most 10 feet / 3 m above the floor.
4. You will need to purchase appropriate hardware for mounting your new reel.
5. The reel base has three 8.5 mm (21/64") drilled holes for mounting on a suitable flat surface.
6. Using the three holes in the base, mount the reel in the desired location. Be sure to use appropriate hardware and
tighten securely.
7. Adjust the cable stopper to the suitable position when required.
6
®
Number
Type
of core
3 H07RN-F
2
3 H07RN-F
2
3 H07RN-F
2
3 H07RN-F
2
Cable
Voltage
length
8 m 230 V
15 m 230 V
20 m 230 V
20 m 230 V
HAE - NLFRENES - v1.1 - 09102013
Full
Full rolled
extended
Watts
Watts
1000 W 2000 W
1000 W 2000 W
1000 W 2000 W
1600 W 3200 W
EN