Metal Works HAE 31508 Manual página 7

5） The reel base has three 8.5mm (21/64") drilled holes for mounting on a suitable
flat surface.
HAE - NLFRENES - v1.1 - 09102013
6） Using the three holes in the base, mount the reel in the desired location. Be
sure to use appropriate hardware and tighten securely.
EN
7） Adjust the cable stopper to the suitable position when required.
Operation
Operation
1. Check reel for correct operation by slowly pulling out the hose. A "clicking" noise
will be heard every half revolution of the drum.
1. Check reel for correct operation by slowly pulling out the cable. A "clicking" noise will be heard every half revolution
of the drum.
2. To latch the reel, pull out the cable and allow it to retract after hearing the first
2. To latch the reel, pull out the cable and allow it to retract after hearing the first second or third "click".
second or third "click".
3. To unlatch, slowly pull out the hose until the "clicking" noise stops, then let the cable retract until the cable stopper
rests against the cable guide.
3. To unlatch, slowly pull out the hose until the "clicking" noise stops, then let the
4. When over loading, the thermal cut-out will cut off automatically, then push the red button until restore.
cable retract until the cable stopper rests against the cable guide.
Note: To avoid damage to the reel, always hold on to the cable while it is rewinding.
4. When over loading, the thermal cut-out will cut off automatically, then push the
red button until restore.
Maintenance
Note: To avoid damage to the reel, always hold on to the cable while it is rewinding.
Make sure the cable is in proper working order and that the insulation is not cut or worn as this could represent a hazard
and jeopardize operation.
Clean the cable with a cloth dipped in warm water to remove dirt or deposits and ensure correct rewinding.
Do not use detergents or solvents which could prove incompatible with cable-winder materials.
If the event of having to perform maintenance on the electrical, mechanical parts or replace the cable, contact an
authorized after-sale service center.
Dismantling of the unit by unskilled personal could prove hazardous; the risk involved mainly concern the preloaded
springs.
Limited warranty
1. The manufacturer warrantees this cable reel against defects in material and craftsmanship, for a period of 24 months
from date of purchase, but not including cable, socket.
2. Manufacturer's liability is limited to replacement or repair of defective material within the warranty period, when
returned freight prepaid to the distributor or their designated service depot.
3. The warranty does not cover damage caused by accident, misuse or faulty installation.
4. The reel must be installed and maintained in compliance with the instructions.
Wall Ceiling
- 4 -
®
0.0
7