Installation Steps; Care And Cleaning - LUND Interceptor Instrucciones De Instalación

Installation Steps

Peel back 2" (5 cm) of tape liner from each flange.
3
Press and hold hood shield against underside lip (leading edge)
of hood while peeling off remaining tape liner.
5
Apply pressure to both flanges to ensure proper adhesion
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Free ends
of tape.
®
branded products offered by Lund International, Inc. We take the utmost pride in our products
800-241-7219 • Visit us at lundinternational.com
© 2012 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Center hood shield on hood. Ensure free ends of tape liner are
4
Remove remaining tape liner by pulling on the free ends.
6
Adjust bumper stops as needed to ensure hood shield
clears grille and headlights. Close hood, Install (3)
bump ons at pre-cleaned areas of hood surface.
8
Lund International
Page 2 of 2
accessible.
Free ends