Operating The Pressure Washer - Silverline 633777 Manual Del Usuario

GB
Unpacking and assembling your
pressure washer
• If any parts are damaged or missing, have these parts repaired or
replaced before assembling or using this product.
• Do not connect the pressure washer to the water, or electrical supply
until fully assembled and ready for use.
• Remove all packaging materials from the product.
Lance Assembly:
• Attach lance (2) to handle (6) by screwing together. Tighten firmly by
hand.
• Attach small end of high pressure hose (10) to brass threads on handle
(6) as shown in the diagram. Tighten with a 17mm spanner.
• Uncoil the rest of the high pressure hose (10)
• Screw the large end of the high pressure hose (10) on to the high
pressure outlet (9) and tighten by hand.
Water Supply
• Ensure the water supply is turned off.
• Pull back the coloured sleeve on the hose connector (3) and pull out the
threaded part.
• Screw the black plastic threaded part on to the water inlet (4) and tighten
by hand.
• Connect the remaining part of the hose connector (3) to your hose.
Loosen the outer ring, push your hose in to the centre, then tighten the
outer ring. Check the connection by tugging on the hose.
• Now reconnect the two parts of the hose connector (3) pushing on to
the water inlet and black plastic part. You will hear a click when the two
parts connect.
• Again, tug on the hose to check the connection.

Operating the pressure washer

• Now that your machine is correctly assembled, check that the switch (5)
is set to "O" – Off position.
• Turn on your water supply.
• Check the water supply connections, and make sure there are no leaks.
Fix any leaks before proceeding.
• Untie the mains lead and fully extend. Plug in to an appropriate mains
supply.
• Switch on by changing switch (5) to "I"
• Hold the assembled lance (2 & 6) firmly with both hands.
• Point away from any person or object.
• Push the safety button (8) in.
• Squeeze the trigger (7) fully in.
• NOTE: On first use the water will not flow evenly. There will be air in the
hose and pipes which will release after a few minutes use.
• To stop the pressure washer, release the trigger (7)
• When not in use, push the safety button (8) so that it prevents the trigger
(7) from moving.
• The spray pattern can be adjusted by holding the lance (2) and turning
the nozzle (1)
Accessories
• Use only approved accessories with this product. Use of anything else
could invalidate your Guarantee and be dangerous.
• The detergent bottle (12) can be attached in place of the lance (2) by
screwing together and tightening by hand.
• The cleaning pin (11) can be used to remove any blockages from the
nozzle (1)
6
633777_Manual.indd 6
Maintenance
Cleaning
• Keep your machine clean at all times.
• Always allow all water to drain from the pump before storing.
Storage
• Always store this machine in a dry place that will not fall below 0˚C
Disposal
• Do not dispose of power tools, or other waste electrical and electronic
equipment, with household waste.
• Contact your local waste disposal authority for information on the proper
way to dispose of tools.
20/5/10 17:33:49