HSM Powerline HDS 150 Manual De Instrucciones página 25

Language selection in "set-up" menu
set-up:
Language

 
next | previous
• Press the Enter button.
 The configured language is shown.
• Select the desired language.
• Confirm the selection
with the Enter key.
System parameters in "set-up" menu
set-up:
System

 
next previous
• Press the Enter button.
 The program version is displayed.
It is necessary to enter a password before you
can query and modify system settings. Param-
eters may only be changed HSM technicians.
01/2018


HSM Powerline HDS 150
7 Troubleshooting
Container full
• Pull out the drawer.
Empty the container.
Place the container in the tray.
push the tray back in.
• Restart the cutting unit. To do so,
press the "Forward" button.
Blockade
 In the event of an overload, the drive switches
automatically and runs in reverse briefly.
Then the cutting unit switches off.
CAUTION
cause injuries even while they are not running.
Protective gloves should be worn at all times.
• Remove the hard drive through the lid.
• Restart the cutting unit. To do so,
press the "Forward" button.
In the event that any fault messages should
appear, switch off the machine and switch
it on again after waiting for a minute.
Inform our customer service if the error contin-
ues to appear.
english
 The "Container full"
indicator lights up.
The status bar is red
and the LED is flashing
red. The cutting unit
switches off after a
brief delay.
The blade rollers can still
25